Prices + Stock updated 23 Aug @ 18:05
1.0mm Nozzle - M6 Thread for MK8 Extruders - Hardened Steel
Hardened Steel nozzle to better resist abrasive materials for 1.75mm filament
Features
Specs
Support
Steel does not conduct heat as well as brass, so a slightly higher printing temperature is usually required.
Next >
• Hole Size: 1.0mm
• Overall length: 13mm
• Thread Length: 5mm
• Inner Hole Size: 2mm (for 1.75mm filament)
• Tip Angle: 70°
• Width across flats: 6mm
• Head diameter: Ø7mm
Product Dimensions: 13 x 7 x 6mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
This product is in the categories:
Related Products:
Buy Now
Nozzle Set for 1.75mm Filament - Brass - MK8 Extruders
Have a range of spare nozzles, heater blocks, silicon socks and tools on hand for when you need them
Buy Now
0.4mm Nozzle - M6 Thread for MK8 Extruders - Hardened Steel
Hardened Steel nozzle to better resist abrasive materials for 1.75mm filament
Buy Now
0.6mm Nozzle - M6 Thread for MK8 Extruders - Hardened Steel
Hardened Steel nozzle to better resist abrasive materials for 1.75mm filament
Buy Now
0.8mm Nozzle - M6 Thread for MK8 Extruders - Hardened Steel
Hardened Steel nozzle to better resist abrasive materials for 1.75mm filament
Buy Now
Acupuncture Needles - 0.3mm - Set of 10
Set of 10 Acupuncture Needles, for clearing nozzles 0.4mm and up
Buy Now
0.5mm Nozzle - M6 Thread for MK8 Extruders - Hardened Steel
Hardened Steel nozzle to better resist abrasive materials for 1.75mm filament
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15