Tested on Blue tape and straight on glass (both cold) with excellet adhesion.


Next > More Information

- On a mini spool (150 x 32mm. 52mm hole)
- Will spiderweb, so choose model well.
- Turn filament fan off during early layers, then print like you would PLA.
- We recommend raising the print temp. slightly compared to regular PLA and reduce the print speed to around 40mm/s to help the filament to just fall out of the nozzle rather than be pushed by the feeder
- Melting Point 190-250 °C


Product Dimensions: 150 x 32 mm. 52mm hole


Next >

We have printed a lot with this material on the Flashforge Dreamer. Settings and info you may find helpful:
Bed Temp: We heat the bed to 50 degrees, unless twin extruding with ABS see below.
Resolution : 200 - 300 micron
Print Speed: 30 mm/second
Temperature: 230 degrees
Nozzle fan: ON (we use the left extruder on the dreamer and tell the default it is PLA so this turns on.
Two Materials: We have printed Flex-PLA and Flex-ABS Both stick/fuse well together. In both cases we use the plastic as the raft. With ABS we raise the bed temp to 110, however also found the higher heat did effect print quality of the flex (perhaps as the filament fan is also turned off).

General Note: Flex is very susceptible to stringy webs between walls (called spider webbing). Reducing temperature defiantly helps, as does slowing print speed. It is interesting that in the heated chamber of ABS printing this is much less, but the quality of the overall flex print is also more poor.
Bilby 3D provides a 1 month Australian, back-to-base warranty of this product (Terms and conditions)
For technical support of this product please read our knowledge bank or log a ticket

10% Bulk Discount available; Order 10 or more filament at once, Prepay for your order, Phone 1800-847-333 to order. Conditions apply.

Material Safety Data Sheet