Raise3D nozzle for printing with abrasive materials such as Carbon Fibre, Tungsten and Boron Carbide.
Fits Pro 2, Pro3 and E2 models. Not suitable for the E2-CF
FeaturesSpecsSupport
1. Abrasion resistance
2. High-Temperature resistance
3. Low friction coefficient as 0.03 with WS2 Coating - Restrains filament accumulation
4. Stable chemical properties - non-toxic, non-corrosive and insoluble
5. Good lubrication and anti-abrasive performance under the highest temperature at 450 °C
6. Ultra low thrust for filament fluidity
In addition to being suitable for normal filaments, the nozzle is also especially suitable for those composite
filaments with abrasive additives such as carbon fiber, steel, wood, boron carbide, tungsten, phosphorescent
pigment, etc., and those high-temperature-resistant filaments such as PEEK, PEKK, PEI, PSU, PPSU
Next >
- Mohs Hardness: 7.8
- Max. Print Temp: 450°C
- Coefficient of Heat Conductivity: 26W/m.k
- CTE: 12µm/m. °C
Product Dimensions: 35x35x18
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Raise3D nozzle for printing with abrasive materials such as Carbon Fibre, Tungsten and Boron Carbide.
Fits Pro 2, Pro3 and E2 models. Not suitable for the E2-CF
Buy Now
0.8mm Raise3D v3 Steel Nozzle with WS2 Coating
Raise3D nozzle for printing with abrasive materials such as Carbon Fibre, Tungsten and Boron Carbide.
Fits Pro 2, Pro3 and E2 models. Not suitable for the E2-CF
Buy Now
Raise E2 Hot End Assembly - Left - 0.4 with a WS2 hardened Nozzle
Left hand Hot End Assembly for the Raise E2 Series with the Raise 3D WS2 Hardened nozzle
Buy Now
Raise3D Pro3 HotSwap Hot End Assembly - WS2 hardened 0.4mm Nozzle
Have a spare hotend on hand and quickly change just by lifting the lever and sliding it out.
It is universal, so will fit either side.
Buy Now
0.4mm Raise3D v3 Toughened M6 Nozzle
Genuine Raise 3D v3 V3H Nozzle 0.4 mm Replacement Part. Fits Pro 2, Pro3 and E2 models. Not suitable for the E2-CF
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
