WaxCast was designed with casting in mind, and meticulously tested for that purpose by a handful of jewelers and engineers across the world.

Through the testing process, MakerJuice perfected the features most sought after in a casting resin:
- Turns from Orange to Yellow when fully cured post-printing (see picture)
- Less than 0.1% residual ash after burnoutPrint
- Non-reactive with common investments such as Plasticast™
- Optimized for 25µm – 50µm layers, but can be adjusted by exposure
- Low degradation of PDMS vat coatings
- Quick layer times
- Low odor for use in commercial settings
- Resistant to most solvents, including alcohol and acetone
- No pigments to settle out

Additionally, WaxCast has some new features not previously seen in affordable casting resins:
- Made with the Highest quality Natural Wax - incorporating natural wax allows you to use normal working wax by attaching to sprues for easy 3D print modification and provides a number of excellent casting characteristics.
- UV Reactive Coloring - it is difficult to know if you post-cured a print properly. With WaxCast, the print changes color from a darker red to a light orange when fully cured.

Next > More Information

What wave length does this resin cure at?
Makerjuice advise that all their resins cure at 420nm and lower. The peak absorption is at 365nm

WaxCast has been tested and works on the following printers:

ANYCUBIC Photon - For 25microns Layers, Normal Exposure=40, Off time=1, Bottom Exposure Time=80, Bottom Layers=6

Asiga Pico Plus - Print Settings

B9Creator 1.2 - Print Settings

Form 1+ - Prints using Castable resin setting, 25µm layers

Form 2 - Prints using Castable resin setting, 25µm layers. MUST USE NEWEST PREFORM AND PRINTER FIRMWARE.

LittleRP - Settings w/Acerx1240, 25micron layers: Burn in layers=15 seconds per layer, 10 layer, All others 1500ms per layer

mUVe 3D DLP - Print Settings

Solus - Print Settings

Tiger3D - Thickness=50, Curing Time=5.00, Speed=Slow, Gap Adj.=0, Base LAyers=1, Base Curing=60, Buffer LAyers=5

Please see the MakerJuice website for usage tips and casting schedule and recommended settings for a variety of printers

Product Dimensions: 210 x 90 x 90mm


Next >

Usage tips and casting scheduleThis product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product