Prices + Stock updated 9 Mar @ 13:04
Polyimide - 20mm wide - 30m long
Polyimide / Kapton Tape, 20mm wide.
The roll is approx 30m long and kapton is approx 0.05mm thick
Features
Specs
Support
Polyimide (also known as Kapton) Tape is a high temperature insulative tape. It uses a silicon based adhesive to withstand temperatures up to 280 °C. It is great around your extruder head for fixing ceramic insulation tape. It can also be used as a general purpose electrical tape with low residue.
Next >
More Information
Product Dimensions: 96 x96 x20
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Polyimide (Kapton) Tape - 6mm wide - 30m long
This Polyimide (also known as Kapton) Tape is a high temperature insulative tape. It uses a silicon based adhesive to withstand high temperatures up to 260 C.
Buy Now
Polyimide (Kapton) Tape - 100mm wide - 30m long
This Polyimide (also known as Kapton) Tape is extra wide (100mm), great for covering your build platform when printing with ABS. The roll is approx 33m long and Kapton is approx 0.02mm thick
Buy Now
Polyimide (Kapton) Tape - 50mm wide - 30m long
This Polyimide (also known as Kapton) Tape is great for covering your build platform or providing electrical insultation. ABS stick to this when hot (with a heated bed), but releases easily when cold.
Buy Now
Thermistor, 100K NTC, Axial Leads - UNTIL SOLD OUT
Use this for sensing the temperature of your hot end, heated bed or whatever you can think of
Buy Now
3D printing Tape (Blue Edgelock) - 48mm wide x 50m long
This blue painters (masking) tape is widely accepted as the standard for covering your bed for printing with PLA.
One roll will completely re-cover a Replicator bed over 50 times, or a prusa bed over 43 times.
Genuine 3M Edge-Lock tape
Buy Now
Ceramic Insulation Tape
This 1 inch wide ceramic tape is used to wrap your heater block and reduce heat transfer to both the extruder and your work piece. Fix by wrapping in kapton tape.
The tape on your Reprap will need replacing from time to time, especially when a print fails and the melted plastic gets caught up in the print head - it can sometimes stick to the ceramic tape and rip it on removal - careful not to pull on the temperature sensor wire!
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
