Prices + Stock updated 21 Nov @ 12:50
The Duex 5 expasion board allows you to run 5 stepper motors, heater cartridges, thermistors and endstops. It also has 6 controlled fan outputs.
The Duex5 has the following features:
- 5 additional TMC2660 stepper motor drivers with stall notification.
- 5 additional extruder heater outputs.
- 5 servo outputs with 5V power and 5V signal levels, sharing control channels with the heaters, so you can use unused heater channels to drive servos.
- 5 additional endstop inputs with indicator LEDs and 3.3V/5V voltage selection. These are also usable as outputs.
- 6 additional controlled fan outputs, also usable for driving LEDs etc. The output voltage may be switched between 5V, 12V and VIN.
- 4 uncommitted general purpose I/O pins.
- 12V switching regulator, for generating a 12V supply for fans, LEDs etc. when the VIN power is higher than 12V.
- 5 additional thermistor inputs.
- Support for 2 more thermocouple or PT100 daughter boards, supporting up to 4 more sensors.
- Optional 5V external power input for powering servos, fans etc.
The Duex2 has the same feature list, just with 2 channels of TMC on board strepper drivers, rather than 5. Both are supplied with the 50 way connector cable between the DuetWifi and the Duex.
Next >
More Information
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Buy Now
Rotating Magnet Filament Monitor for Duet3D Printer Control Electronics
Finally a filament sensor that detects whether the filament is moving!
The magnetic rotary encoder will sense filament presense and movement, so ven knotted spools can be detected.
Buy Now
Duet3D PT-100 High-Temp Sensor with interface board
This sensor and adapter board not only makes temperature sensing more accurate, it also allows you to measure up to 500 °C
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
