This 3d printed part clips on to the existing endstop to protect it from being bent. Kit is supplied with 2 M3 16mm cap screws required to kit the upgrade. See Support TAB for fitting instructions

Next >

2 pin

Product Dimensions: 26 x 30 x 8mm


Next >

How to Fit the Upgrade
You will need a 2.5mm Hex wrench

Step 1: Turn off the power.

Step 2: Locate the Y endstop at the front left corner of the machine (see image 3) Remove the cables which connected to the end stop and undo the cap screws (there is a cushion plate behind it be ready to catch that.

Step 3: Press the protective plate onto the endstop, then seat over the cusion plate and insert the new (longer) cap screws supplied. Screw the assembly back in place. Connect the cable

Step 4 : Turn on power and test endstop is working by HOMEING the Y axis from the SCREEN menu.This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product