This mini Heater block has a variety of pre-drilled and tapped holes for your layout. Anodised Aluminium with chamfered edges. Quality look!
FeaturesSpecsSupport
- 16 x 16 x 12mm (WxDxH)
- Barrel Hole: M6 thread
- Heater Cartridge Hole: 6.25mm diameter with M3 set screw
- Thermistor Hole: 2.1mm diameter
Next >
Product Dimensions: 16 x 16 x 10mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Thermistor Cable for measuring the temperature of Hot ends and heated beds on Reprap, Prusa i3 and similar
Buy Now
0.4mm Nozzle - M6 Thread for MK8 Extruders - Brass
This is the most common nozzle across all 3D Printers. Most notably Makerbot Replicator 1, 2 and 2x, Prusa, older FlashForge
Buy Now
Heater Cartridge - 40W 24V
This ceramic core heater cartridge has a variety of heating possibilities from hot ends/ extruders to heated beds.
Buy Now
Heater Cartridge - 40W 12V
This ceramic core heater cartridge has a variety of heating possibilities from hot ends/ extruders to heated beds.
Suitable for CR-10 Machines.
Buy Now
Stainless Steel Barrel (aka thermal barrier or Heat core)
Stainless Steel Barrel.(aka Throat, Heatbreak)
Connects the heater block to the extruder mounting block or heatsink
Buy Now
Ceramic Insulation Tape
This 1 inch wide ceramic tape is used to wrap your heater block and reduce heat transfer to both the extruder and your work piece. Fix by wrapping in kapton tape.
The tape on your Reprap will need replacing from time to time, especially when a print fails and the melted plastic gets caught up in the print head - it can sometimes stick to the ceramic tape and rip it on removal - careful not to pull on the temperature sensor wire!
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
