Aftermarket Heater Block for the FlashForge Dreamer/Pro/Inv 1-FFD
Aftermarket heater block for the FlashForge Dreamer, Creator Pro and Inventor 1
FeaturesSpecsSupport
Has a M7 tapped (threaded) and recessed hole for the barrel, and nozzle most other printers are M6!
Has an M4 drilled and tapped holes for the thermocoupler (temperature sensor)
Next >
- Thermo connector thread M4
- Block dimensions: 19x19mm, 13mm tall
- Takes a MK10 nozzle and barrel (7mm)
Compatible with: The Flashforge Dreamer, Creator Pro, and Inventor 1.
NOT COMPATIBLE with other Flashforge Models
Note re Cocoon and Wanhao machines: They use an M7 threaded barrel and nozzle, so this is the best heater block to buy, but you will need 2 x M4 grub screws for the Heater block and thermo fitting (your current ones will be m3). ptHeatBlockFFF will work with no m4 screws but is smaller in size, your heater cartridge may extend too long.
Product Dimensions: 19x19x13
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
0.4mm Genuine FlashForge Nozzle - M7 Thread for MK10 Extruder-FFptfe
This is a genuine nozzle from FlashForge. M7 tread.
Buy Now
Flashforge Barrel for Dreamer / Creator Pro / Inventor 1 - FFptfe
Genuine FlashForge barrel. It has a smooth outer tube with flats for holding with a spanner or pliers and a threaded end
Buy Now
Heater Cartridge for Dreamer and Inventor 1 only-FFD > UNTIL SOLD OUT
Genuine Spare part for FlashForge Dreamer and Inventor 1 only heater cartridge.
Note : Flashforge CreatorPro cable is different (see image 3, ptHeatCart4024)
Flashforge Finder, Guider (1 and 2) and Inventor2 also have a short heater. This is not compatible
Buy Now
All Metal Hotend kit for MK10 extruders-FFD-FFtc
Genuine Micro-Swiss all metal hotend upgrade for MK10 style extruders.
MK10 Extruders most notibly used on the FlashForge Dreamer, Inventor1 and Creator Pro 2016 and Dremel Idea Builder. It also fits the Wanhao i3 and Cocoon
Buy Now
FlashForge Thermocoupler - Short for Dreamer-FFD > UNTIL SOLD OUT
Discontinued - Use ptThermoFFshCon and cut the connector off!
Genuine FlashForge thermocoupler
M4 brass fitting at sensing end (Note: our other thermocouplers and heater blocks are all M3)
Crimped terminals at motherboard end
~11cm lead length - Suited to the FlashForge Dreamer which has a terminal board on the extruder carriage
Buy Now
All Metal Hotend with Cooling Block for Wanhao i3
This is Micro Swiss All Metal Hotend kit with redesigned cooling block for Wanhao i3, Wanhao i3 Plus and all other i3 clones with the following improvements:
- Slotted Clamping system
- No set screw to ding and damage thermal tube
- Significantly better heat transfer (this is a big one!!!)
- Easier disassemble and adjustments
- Precise control on bore diameter
This silicon rubber heaterblock cover suits the FlashForge Dreamer and Prusa i3
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
