It has a Wear Resistant High Lubricity TwinClad XT Coating this makes it a excellent choice when printing with abrasive/wearing material such as Bronze, Copper, Alumininium or Carbon Fiber filament. TwinClad XT is a nickel composite coating for very low frction. Over a 360 brass base, it gives a lower coefficient of friction than PTFE (Teflon) over nickel

This is dimensioned the same as our standard nozzle, as used on the Makerbot MK8 extruders.
ALWAYS run preheat before changing nozzles to avoid stripped threads.
Is is compatible with older Ultimaker and FlashForge Creator, as well as Wanhao and CTC


Next >

Hole: 0.4mm hole.
Thread: M6, 5mm Long
Total Length: 13mm.
Head width: 7mm
Base: Flat at screw/thread end
Tip: may have a slight flatened area
Filament Size: suitable for 2.85/3mm filament.
Alternative: 1.75mm filament with 2mm Inner Diameter + 3mm outer diameter PTFE tube
Coating: TwinClad Coated


Product Dimensions: 13 x 7 x 7mm


Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product