Prices + Stock updated 23 Aug @ 18:05
Genuine MakeX Resin Tank/Vat for the M-One, XGA and HD models.
This is the Flex Vat V2.
This breakthrough technology does away with the old silicon resin coated vats, which are easily damged and become cloudy after as few as 10 prints in the same spot.
Instead this tank had a flexible FET film, which lessens the load on the machine when peeling off the print after each layer, PLUS it is easily and (relatively) inexpensively replaced!
Each tank comes with 1 film pre-installed, and a spare for you to use later.
Assembly notes:
- Peel the protective paper of the perspex panel, this sits in the base piece with the perspex UP, so the lower piece is raised in the middle
- Place the tank itself on top, so the raised section pulls the film tight
- Add the fixing screw with spring - wound in about half way only
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product