Prices + Stock updated 23 Aug @ 18:05
This kit includes the items most commonly needed when you are using resin printers:
Features
Specs
Support
250ml Squeeze Bottle - For Isopropyl Alcohol for washing excess resin from your prints
500ml Squeeze bottle - For water to rinse you prints after washing
2 x 3ml Squeeze droppers - For fine washing work or where rough measurement is required
Stainless Steel Funnel with grid and handle - Funnel for returning unused resin to the lightproof bottle. Has a grid for removing any cured resin floating in the vat which you do not want there! The grid easily clips out for washing
Just buy vinyl gloves and a pyrex dish of suitable size from your local supermarket, and you are all set to go!
Next >
Product Dimensions: 200x190x120
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
This product is in the categories:
Related Products:
Buy Now
Photocentric Funnel Filter Paper - with mesh - 25 pcs
Use to filter resin when pouring back into container of origin after use.
Pack of 25pcs
Buy Now
FlashForge Hunter - Resin Printer
This high quality resin printer is designed for applications where very high resolution is essential, such as jewellry and dentistry.
Build size of 120 x 67.5 x 150mm
Buy Now
Raise3D DF Wash Washing Basket
It can be hung on the Rasie3D DF Wash Z-axis with models in it for washing and drying.
Buy Now
Raise3D Hydrometer
This hydrometer measures the specific density of fluids
Buy Now
M-One Resin Tank - Permanent Vat
Genuine MakeX Resin Tank/Vat for the M-One, XGA and HD models.
This is the Flex Vat V2.
This breakthrough technology does away with the old silicon resin coated vats, which are easily damged and become cloudy after as few as 10 prints in the same spot.
Instead this tank had a flexible FET film, which lessens the load on the machine when peeling off the print after each layer, PLUS it is easily and (relatively) inexpensively replaced!
Each tank comes with 1 film pre-installed, and a spare for you to use later.
Assembly notes:
- Peel the protective paper of the perspex panel, this sits in the base piece with the perspex UP, so the lower piece is raised in the middle
- Place the tank itself on top, so the raised section pulls the film tight
- Add the fixing screw with spring - wound in about half way only
Buy Now
Raise3D DF Wash
The DF Wash is the perfect companion to the DF2 UV Resin Printer
Buy Now
Generic Funnel Filter Paper - with Mesh - Pack of 10
Aftermarket paper filter with mesh panels - pack of 10pcs.
Note that the mesh is very fine, and may separate out some pigments from the resin.
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15