Joins the large ribbon cable coming in to the extruder to all the connectors for extruder componants (the motor, sensors and heater cartridge) in the extruder

Note: Current version is marked 0.6

Next >

WARNING:
This board does not fit the orginial and older machines, and other models including
-Guider, Guider 2 and Guider 2s
-Finder
-Inventor 2 (original model)
as some of these machines have an extra 2 pin connector for the side fan and/or a 12V heater cartidge
See alternative products ptBoardExtFFG and ptBoardExtFFF

This version is V0.6

Product Dimensions: 58.1x50x13.2mm


Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product