Prices + Stock updated 22 Nov @ 16:50
Aftermarket 30mm fan, not for use on Flashforge Guider - see specs
- Connector: 2pin 4.52X3.48mm (not compatible with Guider ext board)
- Size: 30* 30 *10mm
- Cable Length: 27cm
- Rated Current: 0.13 Amp±10%
- Rated Speed: 16500RPM±10%
- Air Flow: 1.9CFM±10%
- Noise Level: 20dBA±10%
- Bearing Type: Sleeve Bearing
- Life: 35000 hours
WARNING Flashforge fans are Red-Black pinned opposite to std fans and not interchangable
Product Dimensions: 30 x 30 x 10mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Buy Now
Hot End - E3D v6 clone - 1.75mm Filament, 0.4mm nozzle - Direct Drive
This complete hot end is based on the J-Head design as modified by E3D (V6). Includes everything you need, hot-end wise for 1.75mm filament.Note this is a PTFE lined system
Designed for extruders using direct drive filament feeding (2mm hole at top)
Buy Now
Hot End - E3D v6 clone - 1.75mm Filament, 0.4mm nozzle
This complete hot end is based on the All-Metal J-Head design as modified by E3D (V6). Includes everything you need, hot-end wise for 1.75mm filament
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
