Prices + Stock updated 9 Mar @ 13:04
Heater Cartridge for Guider 2, Inventor 2/2s/se (24V, 18.5 long)-FFptfe-FFtc
Genuine FlashForge replacement part for the Guider 2 (NOT THE GUIDER 1-see specs tab), Inventor 2/2S/2SE
Features
Specs
Support
Compatibile with: Guider 2/2s, Inventor 2/2s/2SE models
Next >
Power: 24V 40W (important: Finder and old guiders are 12 V)
Cartrige Size: 18.5mm long to cables, 6.2mm diameter
Cable: 116mm long, raw wire ends
Compatibile with: Guider 2/2s, Inventor 2/2s/2SE models
Note: Older Guiders use ptheatcartFFG as they are 12V not 24V
Product Dimensions: 125x7.9x24.4mm
Next >
Genuine FlashForge replacement partThis product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
FlashForge Thermocoupler - Short with Molex connector
Genuine FlashForge thermocoupler with 11cm lead length and Molex connector for the Finder, Inventor2 and Guider Series which have a terminal board on the extruder carriage.
Buy Now
Silicone Sock Heater Block Cover for Inventor2 / Guider2 / Finder-FFtc-FFptfe
This cover goes over the heater block to keep the heat where it is meant to be.
Buy Now
Flashforge Barrel for Dreamer / Creator Pro / Inventor 1 - FFptfe
Genuine FlashForge barrel. It has a smooth outer tube with flats for holding with a spanner or pliers and a threaded end
Buy Now
Barrel for Flashforge Guider / Finder - FFptfe
Threaded metal tube that runs between the heater block and the circular heatsink in the extruder
Buy Now
Teflon tube for Flashforge Single Extruder Barrel - FFptfe
This short piece of Teflon tubing is for lining the barrel on the Flashforge Guider, Guider2, Finder, Finder Plus and Inventor 2
Buy Now
Capricorn Teflon tube for Flashforge Single Extruder Barrel - FFptfe
This short piece of Teflon tubing is for lining the barrel on the Flashforge Guider, Guider2, Finder, Finder Plus and Inventor 2
Made from Capricorn XS Tubing, it is higher lubricity and more resistant to the high temperatures experiences in a hot end
Buy Now
MicroSwiss All Metal Hotend Kit for FlashForge Finder, Guider, Inventor 2/2S/2SE-FFtc
Genuine Micro-Swiss all metal hotend upgrade for the FlashForge Guider, Guider 2
Finder, FinderPlus and Inventor2.
Comes with 0.4mm nozzle, range of other sizes available
Buy Now
All Metal Hot End for FlashForge Inventor 2/2S/SE & Guider 2/2S
This hotend fits several FlashForge 3D Printers
Buy Now
FlashForge Hot End Assembly for Guider2s - 300°C - FFam
Genuine Flashforge HotEnd Assembly for the Guider2S
With a brass 0.4mm nozzle and is rated to 300 °C
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
