Nozzle set with toughened drive gear and tools for the Guider2S with a high-temperature hotend. This will have a RED nozzle duct

When the FlashForge Guider2S switched over to a high-temperature hot end, it came with a different nozzle and barrel/heatbreak (with red nozzle duct)

When the FlashForge Guider2S switched over to a high-temperature hot end, it came with a different nozzle and barrel/heatbreak (with red nozzle duct)

When the FlashForge Guider2S switched over to a high-temperature hot end, it came with a different nozzle with a longer thread and barrel/heatbreak (with red nozzle duct)

This cover goes over the heater block to keep the heat where it is meant to be.

This 2022 update to a solid large 3D printer became much quieter, in addition to a flexible bed And spare bed Tape, Toughend filament drive gear, Toughened nozzle (included in the spare parts pack and not fitted) and improved filter. It has a user friendly touchsreen and webcam, plus a generous 280 x 250 x 300mm build volume.
All machines come standard with high-temperature extruders (to 300deg).

Genuine FlashForge spare part

this heater block suits those G2S with the High-Temp (300°C) hotends
Does Not include Grub screw or Bolt

Genuine Flashforge HotEnd Assembly for the Guider2S
With a brass 0.4mm nozzle and is rated to 300 °C

The short barrel / throat / heatbreak for the FlashForge High Temperature hotend, found on leter version of the FlashForge Guider2s (with a red nozzle duct)

26mm length to suit ptHotEndAssFFg2HT - made from Capricorn PTFE Tube

Genuine FlashForge replacement part

For the High-Temp (300°C) hotend with the red cooling duct

Genuine FlashForge thermocoupler with 11cm lead length and Molex connector for the Finder, Inventor2 and Guider Series which have a terminal board on the extruder carriage.