Rapid Model Resin range was originally developed around MSLA printers that used lower-powered LED arrays to cure the resin. The unique, epoxy-based system creates models that process a hard surface finish without the brittleness you would expect.

This resin is easy to use; give the bottle a quick shake then pour and print! The typical normal layer durations for a colour-based MSLA printer are 5-6 seconds per layer or 1.5-3 seconds in a printer with a monochrome LCD.

Rapid Resin only requires a short post-curing required to remove tackiness after cleaning

Next >

All Monocure 3D resins have a very wide range of reactivity, UV wavelengths of 225nm to wavelengths of 420nm. By incorporating a blend of photo-initiators, monomers & sensitizers, almost any UV light source can be used to initiate the polymerisation process.

These resins have been tested with a ‘Shore D Hardness Durometer’ and have a rating of 75. (For example, a hard hat has a rating of 80)

The Viscosity of Moncure3D resin is 500 – 600cps @ 25°C (Brookfield RVT).

All Moncure3D resins have a low odour, have zero VOC emissions and display very low shrinkage properties <0.5%>

Please store Monocure 3D resin in a dark, cool place out of direct sunlight



Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product

10% Bulk Discount available; Order 10 or more filament at once, Prepay for your order, Phone 1800-847-333 to order. Conditions apply.

Material Safety Data Sheet