Just stand these on top of your Raise body and sit one edge of the hood in to the slots.

Works 2 ways to give a small gap or a large gap as desired.

Raise put a sticker on the hood recommending that you remove the hood for printing PLA plastic. Using these stands you can still use the hood - too keep out dust and keep in noise - while still allowing ventilation of the build cavity

Next >

Product Dimensions: 140 x 40 x 30mm


Next >

Bilby 3D provides a 1 month Australian, back-to-base warranty of this product (Terms and conditions)
For technical support of this product please read our knowledge bank or log a ticket