Prices + Stock updated 9 Mar @ 13:04
Thermistor Cartridge - 104GT-2 for E3D v6 and Volcano
A custom made thermistor encapsulated into an easy to use cartridge package.
This sensor is able to measure temperatures up to 300°C
Features
Specs
Support
Includes heatshrink to support cable-cartridge junction if desired.
Includes a 2 pin Servo connector with 10mms of wire and 2 pieces of heat shrink.
*note connect may not suite your machine
Next >
Temperature limit of 310 °C
Recommended printing temperatures under 300 °C
Cartridge Diameter: 2.9mm
Cartridge Length: 14.9mm
Product Dimensions: 115x3x3
Next >
Setttings for your firmware
For Marlin Firmware
* 5 : 100K thermistor - ATC Semitec 104GT-2/104NT-4-R025H42G (Used in ParCan & J-Head) (4.7k pullup)
#define TEMP_SENSOR_0 5
For Smoothieware
temperature_control.hotend.thermistor Semitec
For Repetier
ATC Semitec 104GT-2
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Heater Block for Volcano Hot Ends - Updated
Aftermarket Heater Block for Volcano Hot Ends - (Cartridge Style Thermistors only)
Buy Now
Heater Block Cover - E3D v6 compatible - Silicon
Keep the heat where is should be with this silicon cover. Also helps to keep plastic off your nozzle and heat block
Buy Now
Heater Block - E3D v6 compatible - Aluminium
E3d Style Heater block for Standard thermistor style - (Not Cartridge Style Thermistors)
Buy Now
Heater Block - E3D v6 compatible - Brass
Brass heater blocks are much better able to handle high printing temperatures and speeds
- (Cartridge Style Thermistors only)
Buy Now
Hot End - Volcano Clone - 1.75mm filament, 0.6mm nozzle, 24V
Volcano compatible all metal hotend
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
