Note: This is the only 3DLac product that is not Dangerous goods - so it CAN be sent Express / Air-Freight

3DLAC STICK can be applied on multiple surfaces on which you want to print with 3D printers. Depending on each material, different adherences will be achieved, so we advise you to do previous tests before printing with certain technical materials.
When removing the parts take special care, we recommend waiting until the temperature of the base is below 30 ° C and in case you do not remove the piece, let it cool in the refrigerator and the piece will be released only with a light touch.

Directions for use

• 01 CLEAN_ Ensure that the printing surface is clean and free from debris
• 02 SHAKE_ Shake the bottle very well before use
• 03 PRESS_ Gently press the bottle against the printing surface to activate the adhesive
• 04 SPREAD_ Apply the adhesive onto the printing surface evenly. You can create parallel lines or zigzags according to your preference. Make sure to cover the entire area where you want the print to adhere
• 05 PRINT_ Begin the print job, confident in the reliable adhesion provided by 3DLAC Stick
• 06 REMOVE_ Once the print is finished and the surface has cooled, easily remove your printed object


Next >

Physical Properties

• Binders: Thermoplastic
• Colour: Transparent
• Brightness (ASTM D-523 ISO 2813): Not applicable
• Touch drying (ASTM D-1640 ISO 1517): 15”
• Total drying (ASTM D-1640 ISO 1517): 45”
• Dry film thickness (ASTM D-823 ISO 2808): 15µ /layer
• Adhesion (ASTM D-3359 ISO 2409): 4 B
• Theoretical yield: 2 m2
• Thinner: Water
• Product lifetime: > 5 years
• Over-application: Yes
• Heat resistance: 200°C


Product Dimensions: 35Ø x 142mm


Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product