This aftermarket heat block allows you to push your E3D Volcano style hotend over 500 degrees!
- (Cartridge Style Thermistors only)
FeaturesSpecsSupport
NOTE: Use with a PT100 thermocoupler, which is suited to these higher running temperatures without losing accuracy. If planning to use at regular temperatures (up to 300degrees), then a standard thermocoupler is OK.
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Aftermarket heater block cover for E3D Volcano hot end
Buy Now
Heater Block for Volcano Hot Ends - Updated
Aftermarket Heater Block for Volcano Hot Ends - (Cartridge Style Thermistors only)
Buy Now
Duet3D PT-100 High-Temp Sensor with interface board
This sensor and adapter board not only makes temperature sensing more accurate, it also allows you to measure up to 500 °C
Buy Now
Hot End - Volcano Clone - 1.75mm filament, 0.6mm nozzle, 24V
Volcano compatible all metal hotend
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
