Micro-Swiss FlowTech Hotend for Creality K2 Plus

Made in USA by Microswiss and paired with Bondtech CHT High Flow Nozzles, this hotend delivers up to 50 mm³/sec for ultra-fast printing without compromising quality. Installation is simple and plug-and-play, allowing you to integrate it seamlessly into your Creality K2 Plus printer.

Leak-Proof Nozzle:

Tired of messy nozzle leaks that ruin your prints and waste filament? FlowTech Hotend combines nozzle and thermal break into one permanently sealed assembly that ensures a leak-proof hotend.

Cold Nozzle Change:

Swapping out nozzles used to be a time-consuming and potentially hazardous task. With a FlowTech Hotend, nozzle changes are effortless, and theres no need for hot tightening, and you can do it with just one hand.

CHT High Flow Nozzle Performance:

An official collaboration between Microswiss and Bondtech brings the CHT High Flow nozzle to the FlowTech ecosystem. This nozzle incorporates proprietary CHT technology, specifically engineered to boost the flow rate and improve layer adhesion.

High Flow CHT

The FlowTech nozzle, equipped with Bondtech CHT technology, can achieve a maximum volumetric flow rate of up to 50 mm³/sec

Better layer adhesion

More uniform layer deposition is achieved by splitting the filament flow into multiple chambers as it passes through the melt zone. This reduces gaps and weak points between layers

All-Metal Design

Built to last! FlowTech hotend features an all-metal design that can handle most modern 3D printing filaments. The entire hotend is machined and assembled in-house, with quality control performed at multiple stages during the manufacturing process. At the end, each hotend undergoes a full thermal cycling test before it is packaged.

350°C Max Temperature

This hotend is rated at 350°C temperature with a properly tuned NTC thermistor for each specific printer. This particular edition is perfectly tuned for Creality K2 Plus so no firmware changes are needed.

Next >

In the Box:
• 1x FlowTech™ Heater Core
• 1x FlowTech™ CM2 CHT 0.4mm Nozzle
• 1x Heatsink
• 2x Titanium Mounting Screws
• 1x Silicon Sock



Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product