This is a genuine FlashForge replacement sheet for the Inventor 2 / 2S and 2SE printing bed.
FeaturesSpecsSupport
Very similar to BuildTak, it gives unrivalled performane for getting items to stick to the bed for less warping and less print failures.
At 165x155mm, this tape is also a great size for an Da Vinci Jnr, UP Plus 2 or UP Mini and is compatible with a heated bed.
We have tested this bed surface with PLA, ABS, Nylon and PETG.
Tip: When removing the old tape, the glue is very aggressive. We recommend pre-heating to 80-100°C Peel off the old tape and use it side down) to wipe off any remaining glue. Allow to cool before fitting new sheet
Next >
165 x 155mm, 0.6mm thick with the self-adhesive backing paper still on
Product Dimensions: 165 x 155 x 1mm
Next >
Please clean with a clean cloth, a damp cloth, or slightly soapy cloth (then make sure you get all the soap off!).
Acetone or IsoPropyl Alcohol will ruin this surface - DO NOT USE!This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
B3D Bed Tape - for Inventor 2/2S/2SE - 165 x 155mm
This custom bed tape is self-adhesive and is perfectly size to suit the FlashForge Inventor 2 Special Edition
Buy Now
Dreamer / Inventor / CreatorPro Blue Print Bed Tape, 23x15cm
This is a genuine FlashForge replacement sheet for the FlashForge Dreamer, Inventor1, Creator Pro 2016 (v5) and Creator Pro2 (IDEX) printing bed.
It is similar to BuildTak but with more texture on the surface, and a very aggressive glue that does not like to dissolve
Buy Now
Buildtak Spatula
With a right angled handle and a blade that is very thin at the front edge, this is a great tool for getting those really well stuck prints off the bed!
Buy Now
Plastic Scraper with soft edge
This plastic scraper is ideal for smoothing tape onto your priter bed, and helping to remove prints and waste from your bed. One edge is sharp, the other has a soft fabric glued on (similar to loop velcro)
Buy Now
B3D Bed Tape - for Inventor 2/2S/2SE - 165 x 155mm - 10 pack
This custom bed tape is self-adhesive and is perfectly size to suit the FlashForge Inventor 2 Special Edition.
Save with a packet of 10pcs
Buy Now
BOX of 3DLac PLUS Bed Spray - 100ml Spray Bottle - Box of 12
Bed Adhesion and Anti-Warping Spray - easily spray a fine mist on your bed to ensure the print stays where it should, but still removes without fuss.
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
