Thermistor Cartridge - 104GT-2 for E3D v6 and Volcano
A custom made thermistor encapsulated into an easy to use cartridge package.
This sensor is able to measure temperatures up to 300°C
FeaturesSpecsSupport
Includes heatshrink to support cable-cartridge junction if desired.
Includes a 2 pin Servo connector with 10mms of wire and 2 pieces of heat shrink.
*note connect may not suite your machine
Next >
Temperature limit of 310 °C
Recommended printing temperatures under 300 °C
For Smoothieware
temperature_control.hotend.thermistor Semitec
For Repetier
ATC Semitec 104GT-2
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Aftermarket Heater Block for Volcano Hot Ends - (Cartridge Style Thermistors only)
Buy Now
Heater Block - E3D v6 compatible - Aluminium
E3d Style Heater block for Standard thermistor style - (Not Cartridge Style Thermistors)
Buy Now
Heater Block Cover - E3D v6 compatible - Silicon
Keep the heat where is should be with this silicon cover. Also helps to keep plastic off your nozzle and heat block
Buy Now
Hot End - Volcano Clone - 1.75mm filament, 0.6mm nozzle, 24V
Volcano compatible all metal hotend
Buy Now
Heater Block - E3D v6 compatible - Brass
Brass heater blocks are much better able to handle high printing temperatures and speeds
- (Cartridge Style Thermistors only)
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
