This Arm pivots down on the Guider, Inventor 2/2SE and Finder with the level sensor screwed on to it.
The arm attaches to the Bed sensor motor.
DOES NOT WORK/FIT ON A GUIDER 2, see ptSensorBedArmFFG2. This arm differs from that arm as the spoon area is squared. The Guider 2 one has a cut out in the top right of the spoon.
FeaturesSpecsSupport
Next >
Black injection moulded arm that is 60mm long, 12mm at the widest point and 5mm thick.
Product Dimensions: 60X12X5mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
FlashForge Bed Level Sensor Board (Guider / Finder / Inventor 2)
This is the sensor that detects the bed on a Guider, Guider2, Finder and Inventor 2. It is screwed onto the sensor arm, which is then attached the the motor (both sold seperately). It can get broken if level is very out or in cases of extreem print fails. BE AWARE older editionsl of original Guider use a square board, not this part-see PTsensorFF.
Buy Now
FlashForge Bed Level Sensor Motor (Guider / Finder/Inventor)
Genuine Flash forge Level sensor Motor
Fits Guider, Finder and Inventor series printers
Buy Now
FlashForge Bed Sensor Arm (Guider2 / 2s)
This Arm pivots down on the Guider 2, with the level sensor screwed on to it.
The arm attaches to the Bed sensor motor.
DOES NOT WORK/FIT ON A GUIDER 1, Inventor 2/2SE and Finder, see ptSensorBedArmFF. This arm differs from that arm are in that it has a cut out in the top right of the spoon.
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
