BuildTak PEI Bed Tape 500x500mm - Creality CR-10 S5
BuildTak Polyetherimide (PEI) Print Surface. Now you can choose the print surface best-suited to the material being printed.
Slightly less model adhesion than the original BuildTak, it is recommended where consistant prints are required, but a bit easier to remove the print, such as large and PETG prints.
This size fits the CR-10 S5 bed. It can be easily trimmed to size/shape wth a knife or scissors
FeaturesSpecsSupport
Manufactured in the US to ensure consistent quality and composition, BuildTak Polyetherimide (PEI) build surfaces are made from premium Ultem 1000 PEI equipped with the no-cleanup BuildTak Original adhesive.
A comparable alternative to the BuildTak Original 3d printing surface, BuildTak PEI exhibits slightly different adhesion and release properties which vary depending on the material being printed.
In general, BuildTak PEI offers easier release of finished prints while BuildTak Original offers a stronger hold during printing.
Paired with the BuildTak FlexPlate System, you can keep multiple FlexPlates on-hand to easily swap out between the BuildTak Original and BuildTak PEI print surfaces, depending on the material being printed.
For example, Polycarbonate requires BuildTak’s extra-strong hold to finish prints successfully, while PEI should be used for PETG because of its easier release.
PLUS! BuildTak PEI and BuildTak Original are both 0.25mm (0.010in) so no need to re-level when swapping!
Next >
Genuine BuildTak PEI Build Surface
- 500mm wide
- 500mm deep
- 0.254mm thick - same as Original BuildTak
- BuildTak no/low clean-up adhesive
Product Dimensions: 500 x 500 x 0.4mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Genuine BuildTak build tape from the USA. 500 x 500mm size
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
