Leave no ash behind after burning out. This jewelry castable resin uses a special formula to ensure perfect casting results, featuring low thermal expansion coefficient and optimized burnout performance.

Storage:

1. Please keep the resin at room temperature (15 - 35 degrees Celsius) and Sealed storage, the lower the temperature, the higher the viscosity of the resin.
2. Keep away from light seals at room temperature.

Usage:

1. Shake well before use, prohibiting the use of resin in places where there is a lot of sunlight.
2. Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.
3. Printed models need to use high-concentration alcohol to clean about the 30S (recommended concentration of 95% or more, the higher the better)

Next >

Product Dimensions: 85 x 125 x 220mm


Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product