This new formulation is higher performing, more obviously heat treatable, and lower cost. This tough PLA prints with ease but has a potential Heat Deflection Temperature (HDT) of as much as 155°C (310°F) depending on post-processing. This means parts retain more stiffness and form at higher temperatures (no warping on your sunny car dashboard).

Abrasive materials like Carbon Fiber and Metal Composites may cause premature wear of in line components such as bowden tubes, drive gears, nozzles, and other items in the filament travel path. Serviceable hardware including replaceable nozzles suggested. Wear resistant nozzles are recommended for extended use.

Use standard PLA parameters with standard build surface preparation (blue tape, glue stick, or BuildTak). No heated bed required. Some shrinkage may occur in the annealing process, so dimension critical parts may need to be scaled as much as 2.5% to compensate.

Next > More Information

Prints with standard PLA settings, on a cold bed.
For maximum performance, your prints should be heat treated (i.e. crystallized) in an oven until you see a change from translucent to opaque. There is an obvious visual change indicating the improved performance! We had good luck in a lab oven at 110°C (230°F) for an hour or less. We recommend leaving the supports on your parts, placing them on a non-radiating surface (like glass, ceramic, or composite), and letting them cool in the oven to minimize distortion. Parts can be baked at a lower temperature (though must be above 60°C for any change to occur) for a longer time with less risk of unwanted deformation.

Aprox. Length: 180m


Product Dimensions: 205 x 205 x 48mm


Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product

10% Bulk Discount available; Order 10 or more filament at once, Prepay for your order, Phone 1800-847-333 to order. Conditions apply.

Material Safety Data Sheet