Prices + Stock updated 29 Nov @ 17:20
This is the sensor that detects the bed on a Guider, Guider2, Finder and Inventor 2. It is screwed onto the sensor arm, which is then attached the the motor (both sold seperately). It can get broken if level is very out or in cases of extreem print fails. BE AWARE older editionsl of original Guider use a square board, not this part-see PTsensorFF.
Suits many FlashForge machines, please compare your with the image.
• Guider
• Guider 2
• Guider 2S
• Finder
• Finder 2
• Inventor 2
• Invertor 2S
• inventor 2SE
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Buy Now
FlashForge Bed Sensor Arm (Guider / Finder)
This Arm pivots down on the Guider, Inventor 2/2SE and Finder with the level sensor screwed on to it.
The arm attaches to the Bed sensor motor.
DOES NOT WORK/FIT ON A GUIDER 2, see ptSensorBedArmFFG2. This arm differs from that arm as the spoon area is squared. The Guider 2 one has a cut out in the top right of the spoon.
Buy Now
FlashForge Bed Level Sensor Motor (Guider / Finder/Inventor)
Genuine Flash forge Level sensor Motor
Fits Guider, Finder and Inventor series printers
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
