Creality SpacePi X4 - 4 Spool Dryer

• 360° Hot Air Circulation - The 360° surrounding hot air circulation ensures efficient heating and consistent temperature, allowing for uniform drying of filaments inside the chamber.
• Desiccant Regeneration - The desiccant chamber connects to the heating airflow, regenerating the desiccant automatically with each use. No replacement needed, providing a hassle-free and efficient drying process.
• Active Dehumidification - Dual dehumidifying fans actively expel moisture during drying, no manual dehumidification.
• One-Way Valve Design - Closes off chamber after drying to avoid moisture ingree.

• 4 Spools Dry and Print at Once for Maximum Efficiency
• Dual Independent Heating Chambers
• 200W + 200W PTC Heats Up to 85°C
• Active Dehumidification
• Desiccant Regeneration
• Auto Silent & EDry UI
• Triple Safety Protection
• Easy to use touchscreen interface
• Adjustable temperature and drying time
• Programmable material presets
• 3.2 touchscreen for easy operation
Note: No PTFE filament guide tube is included - please order separately if required

Recommended Material Settings

• PLA - 50°C
• PETG - 60°C
• TPU - 60°C
• ABS / PET / PC / ASA / PA/ PAHT - 80 - 85°C - Check the spool can withstand it
Note: We have tested Spectrum, Bilby3D, Bilby Basics (cardboard and plastic) and Raise3D (cardboard and plastic) spools in the SpacePi (85°C, 3+hours) without the spools distorting of coming apart.

Next >

• Heat up to 85°C
• Drying cycles up to 8 hours long
• Single Chamber power consumption: 0.124 kWh (for 85°C)
• Dual Chamber power consumption: 0.208 kWh (for 85°C)

Fits Spools Sizes up to

• 200mm diameter
• 150mm wide
• Designed for 1.75 and 2.85mm filament



Next >

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product