This ceramic core heater cartridge has a variety of heating possibilities from hot ends/ extruders to heated beds.
FeaturesSpecsSupport
24 V, 40 W ONLY
Resistance: 6.8 Ohm
Diameter: 6mm
Length: 20mm
Lead Length: 100cm - fibreglass insulated
Connectors : None (raw cable end)
It is a 10 strand braided cable 1.05mm in diameter double sheathed
Next >
This cable suits many machines including the Creator Pro (not FlashForge Creator Pro2). We can confirm that the cable is 1 meter long (the same as the Flashforge cable) and the cartridge fits in a standard flashforge heater block.
Product Dimensions: 23x6x6mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
This Polyimide (also known as Kapton) Tape is a high temperature insulative tape. It uses a silicon based adhesive to withstand high temperatures up to 260 C.
Buy Now
Heater Block for MK8 Extruders
Aluminium Heater Block 20x20x10mm &plusmin;1mm.
Buy Now
Hot End - E3D v6 clone - 1.75mm Filament, 0.4mm nozzle - Direct Drive
This complete hot end is based on the J-Head design as modified by E3D (V6). Includes everything you need, hot-end wise for 1.75mm filament.Note this is a PTFE lined system
Designed for extruders using direct drive filament feeding (2mm hole at top)
Buy Now
Heater Block - v5 Aluminium Mini Size
This mini Heater block has a variety of pre-drilled and tapped holes for your layout. Anodised Aluminium with chamfered edges. Quality look!
Buy Now
Heater Cartridge - short cables
This heater cartrige has short (10cm long) cables with a molex male pin connector. The cartrige is 23mm long and 6mm in diameter. It is made in Australia by Bilby3D and is a non-genuine exchange for the Makerbot Replicator 2 and 2X heater cartrige.
Buy Now
Hot End - Volcano Clone - 1.75mm filament, 0.6mm nozzle, 24V
Volcano compatible all metal hotend
Buy Now
Hot End - E3D v6 clone - 1.75mm Filament, 0.4mm nozzle
This complete hot end is based on the All-Metal J-Head design as modified by E3D (V6). Includes everything you need, hot-end wise for 1.75mm filament
Buy Now
Heater Cartridge for Dreamer and Inventor 1 only-FFD > UNTIL SOLD OUT
Genuine Spare part for FlashForge Dreamer and Inventor 1 only heater cartridge.
Note : Flashforge CreatorPro cable is different (see image 3, ptHeatCart4024)
Flashforge Finder, Guider (1 and 2) and Inventor2 also have a short heater. This is not compatible
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
