Prices + Stock updated 9 Mar @ 13:04
Heater Cartridge - 40W 24V
This ceramic core heater cartridge has a variety of heating possibilities from hot ends/ extruders to heated beds.
Features
Specs
Support
24 V, 40 W ONLY
Resistance: 6.8 Ohm
Diameter: 6mm
Length: 20mm
Lead Length: 100cm - fibreglass insulated
Connectors : None (raw cable end)
It is a 10 strand braided cable 1.05mm in diameter double sheathed
Next >
This cable suits many machines including the Creator Pro (not FlashForge Creator Pro2). We can confirm that the cable is 1 meter long (the same as the Flashforge cable) and the cartridge fits in a standard flashforge heater block.
Product Dimensions: 23x6x6mm
Next >
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Polyimide (Kapton) Tape - 6mm wide - 30m long
This Polyimide (also known as Kapton) Tape is a high temperature insulative tape. It uses a silicon based adhesive to withstand high temperatures up to 260 C.
Buy Now
Heater Block for MK8 Extruders
Aluminium Heater Block 20x20x10mm &plusmin;1mm.
Buy Now
Heater Cartridge - short cables
This heater cartrige has short (10cm long) cables with a molex male pin connector. The cartrige is 23mm long and 6mm in diameter. It is made in Australia by Bilby3D and is a non-genuine exchange for the Makerbot Replicator 2 and 2X heater cartrige.
Buy Now
Heater Block - v5 Aluminium Mini Size
This mini Heater block has a variety of pre-drilled and tapped holes for your layout. Anodised Aluminium with chamfered edges. Quality look!
Buy Now
Hot End - E3D v6 clone - 1.75mm Filament, 0.4mm nozzle
This complete hot end is based on the All-Metal J-Head design as modified by E3D (V6). Includes everything you need, hot-end wise for 1.75mm filament
Buy Now
Hot End - E3D v6 clone - 1.75mm Filament, 0.4mm nozzle - Direct Drive
This complete hot end is based on the J-Head design as modified by E3D (V6). Includes everything you need, hot-end wise for 1.75mm filament.Note this is a PTFE lined system
Designed for extruders using direct drive filament feeding (2mm hole at top)
Buy Now
Hot End - Volcano Clone - 1.75mm filament, 0.6mm nozzle, 24V
Volcano compatible all metal hotend
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $15
Sydney - Kingsgrove, NSW
Melbourne - Clayton, VIC
