Complex Geometry - PolyDissolve™ S1 is a preferable solution when printing complex geometries, overhangs, internal cavities and complicated structures. It liberates you from support removal problems, and enables greater design freedom.

Wide Material Support - PolyDissolve™ S1 is engineered to have a good adhesion and perfect interface with a variety of supported materials from Polymaker including Nylon, PLA, TPU and PVB.

Water Soluble - Optimized to dissolve in water, supports printed in PolyDissolve™ S1 will dissolve in tap water. Safe and easily accessible!

Improved Surface Quality - Greatly improve the surface quality where supports interface with your prints when using PolyDissolve™ S1.

Quality Control - Polymakers leading quality control process and rigorous in-house testing, ensure reliable printing and consistency across spools and batches.

Next >

Print Settings

Nozzle Temperature: 215°C – 225°C
Printing Speed: 20mm/s – 40mm/s
Bed Temperature: 25°C – 60°C
Bed Surface: Glass with glue, blue tape
Cooling Fan: ON

Material Compatibility

PLA based material from Polymaker’s portfolio + +
PETG based material from Polymaker’s portfolio +
ABS based material from Polymaker’s portfolio – –
PC based material from Polymaker’s portfolio – –
PVB based material from Polymaker’s portfolio + +
TPU based material from Polymaker’s portfolio + +
Nylon based material from Polymaker’s portfolio + +
__________________________________

+ + support the model very well
+ generally support the model depending on its geometry
– generally doesn’t support the model depending on its geometry
– – do not support the model

Notes

Drying Settings: 80°C for 12h
Other: It is highly recommended to use the PolyBox™ when printing with PolyDissolve™ S1 and to store it in the resealable bag.

Product Dimensions: 200Ø x 50mm


Next >

We have extensive tested this product on the Raise Pro 2 printers with PLA and PA6-carbon fibre, with perfect and repeated success. We extruded at 220deg C, using a heat bed btw 30-60, and always with the dis- solvable as the raft.

You will need to change some settings at slicing.
- You need a ZERO Raft to model gap
- Print Speed must be less than 40mm/sec, we found 20mm was best
- You MUST make sure the raft prints no faster than 20mm/sec
All of these are easily adjusted in Raise 3D slicer IDEAMAKER under the advanced tab.

IMPORTANT : we have had no success with TPU. In worldwide discussions it seems we are not alone and are looking at alternative dissolvables for TPU This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Material Safety Data Sheet

Technical Data Sheet