Complex Geometry - PolyDissolve™ 2 is a preferable solution when printing complex geometries, overhangs, internal cavities and complicated structures. It liberates you from support removal problems, and enables greater design freedom.

Wide Material Support - PolyDissolve™ S2 displays an excellent surface adhesion with PC, ABS and ASA based materials which unlocks new applications requiring more complex geometries.

Heat Resistance - The heat resistance of PolyDissolve™ S2 allows it to be printed in the printing environment required to print PC, ABS or ASA (up to 80°C chamber temperature), without collapsing.

Soluble Supports - PolyDissolve™ S2 is a Polyacrylate support material that can be dissolved in warm alkaline water by using PolyDissolve™ S2 solute.

Improved Surface Quality - Greatly improve the surface quality where supports interface with your prints when using PolyDissolve™ S2.

Quality Control - Polymakers leading quality control process and rigorous in-house testing, ensure reliable printing and consistency across spools and batches.


Next >

Print Settings

Nozzle Temperature: 230°C – 250°C
Printing Speed: 30mm/s – 40mm/s
Bed Temperature: 90°C – 110°C
Bed Surface: Works on most heatd surfaces
Cooling Fan: OFF

Material Compatibility

PLA based material from Polymaker’s portfolio N/A
PETG based material from Polymaker’s portfolio N/A
ABS/ASA based material from Polymaker’s portfolio + +
PC based material from Polymaker’s portfolio + +
PVB based material from Polymaker’s portfolio N/A
TPU based material from Polymaker’s portfolio N/A
PA12 based material from Polymaker’s portfolio +
__________________________________

+ + supports the model very well
+ generally supports the model depending on its geometry
– generally doesn’t support the model depending on its geometry
– – does not support the model


Product Dimensions: 200Ø x 50mm


Next >

We have extensive tested this product on the Raise Pro 2 printers with PLA and PA6-carbon fibre, with perfect and repeated success. We extruded at 220deg C, using a heat bed btw 30-60, and always with the dis- solvable as the raft.

You will need to change some settings at slicing.
- You need a ZERO Raft to model gap
- Print Speed must be less than 40mm/sec, we found 20mm was best
- You MUST make sure the raft prints no faster than 20mm/sec
All of these are easily adjusted in Raise 3D slicer IDEAMAKER under the advanced tab.

IMPORTANT : we have had no success with TPU. In worldwide discussions it seems we are not alone and are looking at alternative dissolvables for TPU This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Material Safety Data Sheet

Technical Data Sheet